Sharp ER-A520 - Manual (Page 134)

132
Color Video Monitor (CVM) control character
(Dynamic UPC file)
This programming enables you to assign each PLU/UPC with a number that can be used as a CVM control
character. This number is converted to a two-digit character code that is transmitted for use with a CVM device.
For each PLU/UPC
For a range of PLUs
For a range of PLUs: PLU codes must have already been defined. If not, an error message "NO
RECORD" will appear on the display.
Programming 16 as CVM control character for PLU1
For each PLU/UPC
Programming the range PLU11 through 20 for CVM control character 16
For a range
of PLUs
2234 . @
11 @ 20 @
16 t
Ç
Print Key operation
Character code
converted
2258 . @
1 @ 16 t
Ç
Print Key operation
Example
Note
Procedure
2059
2234 2258 PGM 2
2258
2059
. @ @ t Ç
PLU code
(max. 5 digits)
CVM control character
(0 - 255)
To program any PLU/UPC
To program zero
To program for the following PLU/UPC
Ä
UPC code
(6 to 13 digits)
2234
. @
@ @ t Ç
End PLU code
(max. 5 digits)
CVM control character
(0 - 255)
To apply the current setting of
start PLU code to PLUs within the range
Start PLU code
(max. 5 digits)