Panel mounting – Simrad HS50 User Manual
Page 23
INSTALLATION
20221081 / F
15
Panel mounting
Two mounting methods may be used when panel mounting the
HS50 Display unit.
A drilling template, part no. 22084883, is supplied with the
HS50 documentation. Use this template when making panel cut-
out and drilling holes.
Gasket
1
Remove the front panel corners.
2
Drill the mounting holes and make panel cut-out according
to supplied template.
3
Use the supplied gasket (part no. 22084693) between the
panel and the unit.
4
Fasten the Display unit to the panel with the supplied 19
mm screws.
5
Apply the front panel corners.
6
Connect the Processing unit cable to the Display unit
connector.
Caution!
Do not over-tighten the mounting screws.
Alternative panel mounting
This way of mounting is simpler, but will lift the unit from the
panel surface. When installed adjacent to Simrad MarineLine
equipment there will be a 5.5 mm (0,22") difference in height
between the Display unit and other equipment.
Gasket
1
Remove the front panel corners.
2
Use the template and drill hole(s) only for the connectors.
3
Place the 7.5 mm gasket (part no. 22086029) between
panel and unit, correctly oriented (see marking on gasket).
4
Fasten the Display unit to the panel with the supplied 19
mm screws.
5
Apply the front panel corners.
6
Connect the Processing unit cable to the Display unit
connector.