Simrad HS50 - Manual (Page 32)

Simrad HS50 Heading Sensor
24
20221081 / F
3.7 Software setup procedure
This chapter describes a number of installation settings that
must be performed as part of the installation of the HS50.
Failure to correctly set the values in the installation settings may
prohibit the product from functioning properly.
Before attempting to turn on the HS50 and perform an
installation setup, the hardware and electrical installation must
be completed in accordance with the installation instructions.
The SETUP menu is entered on the Display unit by pressing and
holding the
SETUP button for 5 seconds.
The settings are grouped into the following functional
categories:
• Display adjustments
• Diff. corrections
• Data output 1
• Data output 2
• Ethernet
• General
• (Expert Setup, refer page 30)
Use the arrow buttons to select category, and the
rotary knob to enter a category’s submenu.
The arrow buttons are also used to return from a submenu to the
SETUP menu.
Note! Activate and Discard selection together with the rotary knob is
used to exit the SETUP menu: changes are accepted by using
Activate, and all changes are erased when selecting Discard.