Cable connections – Simrad HS50 User Manual
Page 27
Advertising
INSTALLATION
20221081 / F
19
Cable connections
Proceed as follows to connect the cables to the Processing unit:
1
Remove the bottom cover (terminal cover) to get access to
the plug-in terminals.
2
Strip 1 cm (0.4") of the cable's insulation and pull the
screen backward to cover the insulation. Position the
straps as shown in the figure below and tighten well to
make sure the screen has good contact.
3
Provide sufficient wire length so that the plug-in terminals
can be easily connected/disconnected.
4
Pull out each terminal before connecting the wires.
Remove all stands before putting on the terminal cover.
Advertising