Samsung SCX-6322DN - Manual (Page 77)

13 .10
<Maintenance>
Checking the machine’s serial number
When you call for service or register as a user on the Samsung website,
the machine’s serial number may be required.
You can check the serial number by taking the following steps:
1 Press Menu until Admin Setup appears on the bottom line of the
display and press OK.
2 Press the Scroll buttons until Maintenance appears and press OK.
3 Press the Scroll buttons until Serial Number appears and press
OK
.
4 Check your machine’s serial number.
5 Press Stop/Clear to return to Standby mode.
System Administrtion Tools
The System Admin Tools menu contains a number of parameters and
features that may be configured which are categorized as System
Administration Tools. These particular tools are placed in the System
Admin Tools menu to provide an optional level of protection. The System
Admin Tools menu may be protected by enabling the need to enter a
password to access the menu.
The following options and features are accessed through the System
Admin Tools menu. Some of these features have been discussed in a
separate chapter:
• Password Protect - enables or disables the need to enter a password
to protect the System Admin Tools menu.
• Change Password - changes the password used to access the
System Admin Tools menu.
• Network Setup - sets the network configuration for this machine. For
details, see 3.1 page.
• Email Setup - sets the e-mail configuration for this machine. For
details, see page 11.1.
• Mailbox Setup - creates or deletes mailboxes. For details, see page
9.9.
• Department Codes - enables or disables the department code.
• Maintenance - provides several maintenance options.
• Forward - sets the machine to forward fax or email messages. For
details, see page 9.8.
• Clear Setting - clears the machine’s memory.
Password Protect
The System Admin Tools options may be protected by setting this option
to Yes. When this option is set to Yes, accessing the System Admin Tools
will require entering the password.
To enable the password required for the System Admin Tools menu:
1 Press Menu until Admin Setup appears on the bottom line of the
display and press OK.
2 Press the Scroll buttons until Password Protect appears and
press OK.
3 Press the Scroll buttons, select Yes to enable this feature and enter
the password. You may use up to 4 digits for the password. If you
select No, this feature turns off.
4 Press Stop/Clear to return to Standby mode.