Samsung SCX-6322DN - Manual (Page 82)

14 .4
<Troubleshooting>
In the multi-purpose tray
1 If the paper is not feeding properly, pull the paper out of the
machine.
2 Open and close the front cover to resume printing.
In the fuser area or around the toner cartridge
Note
The fuser area is hot. Take care when removing paper from the
machine.
1 Lift the release lever to open the side cover.
2 Pull down on the fuser lever as shown below.
This will release pressure on the paper.
If paper is not seen in this area, skip to the Exit Area.
Note
Do not pull paper up through the fusing unit. Unfused toner may
adhere to the area, resulting in smudged copies.
3 Remove the jammed paper, in the direction shown.
4 Push the fuser lever up, and then close the side cover.
5 Open and close the front cover to resume printing.
In the paper exit area
1 Press the release lever to open the side cover.