Samsung SCX-6322DN - Manual (Page 84)

14 .6
<Troubleshooting>
In the duplex unit area
If the duplex unit is not inserted correctly, paper jam may occur. Make
sure that the duplex unit is inserted correctly.
1 Press the release lever to open the side cover.
2 Remove the jammed paper.
3 Close the side cover.
Tips for avoiding paper jams
By selecting the correct media types, most paper jams can be avoided.
When a paper jam occurs, follow the steps outlined on page 14.2.
• Follow the procedures on page 5.5. Ensure that the adjustable guides
are positioned correctly.
• Do not overload the tray. Ensure that the paper level is below the
paper capacity mark on the inside wall of the tray.
• Do not remove paper from the tray while your machine is printing.
• Flex, fan, and straighten paper before loading.
• Do not use creased, damp, or highly curled paper.
• Do not mix paper types in a tray.
• Use only recommended print media. See page 5.8.
• Ensure that the recommended print side of print media is facing down
in the tray, or facing down in the multi-purpose tray.
Understanding display messages
Messages appear on the Smart Panel program window or the control
panel display to indicate the machine’s status or errors. Refer to the
tables below to understand the messages’ meaning and correct the
problem if necessary. Messages and their meanings are listed in
alphabetical order.
Note
When you call for service, it is very convenient to tell the service
representative the display message.
Message Meaning Suggested solutions
Authentication
Failure The ID or password
you entered is
incorrect. Enter the correct ID or
password.
Cancel?
Yes
Your machine’s
memory has
become full while
trying to store an
original into memory. To cancel the fax job,
press the OK button
to accept Yes.
If you want to send
those pages that have
been successfully
stored, press the OK
button to accept No.
You should send the
remaining pages later,
when memory is
available.
[COMM. Error] The machine has a
communication
problem. Ask the sender to try
again.
Connection Error Connection with the
SMTP server failed. Check the server
settings and the
network cable.
Connection Failed The protocol you
have entered is not
supported or server
port is wrong. Check the protocol or
server port.
[Document Jam] The loaded original
has jammed in the
ADF. Clear the jam. See
page 14.1.
Door Open The front cover or
rear cover is not
securely latched. Close the cover until it
locks into place.
Drum Warning The drum cartridge
is near the end of its
life. You should ensure a
replacement cartridge
in stock.
Enter Again You entered an
unavailable item. Enter the correct item
again.