Sony HT-K250 - Manual (Page 18)

masterpage:Left
filename[\\Nas-data-server\SONY Current jobs\SONY HT-
K250\DTP\4247255111\424725511HTK250CEL\01GB04BSC_HT-K250_CEL.fm]
18 GB
model name1[HT-K250]
[4-247-255-11(1)]
Switching the display
(vertical/horizontal)
You can switch the display as follows depending
on how you place the control center (page 13).
Press DISPLAY POSITION repeatedly.
Each time you press the button, the display
layout changes.
You can receive FM/AM broadcasts with the
tuner in this system.
Before receiving broadcasts, make sure you
have connected FM and AM antennas to the
receiver (page 9).
Tip
You can tune in the station in 50 kHz steps for
FM band and 9 kHz steps for AM band.
Manual tuning
Use the numeric buttons on the remote to input
the frequency of the station.
1
Press TUNER.
You can also use INPUT SELECTOR on
the control center.
2
Press TUNER repeatedly to select FM
or AM band.
3
Press D.TUNING.
The ALT button lights up.
4
Press the numeric buttons to input the
frequency of the station.
Example 1: FM 102.50 MHz
Press 1 t 0 t 2 t 5 t 0.
Example 2: AM 1,350 kHz
Press 1 t 3 t 5 t 0.
If you have tuned in an AM station, adjust
the direction of the AM loop antenna for
optimum reception.
If you cannot tune in a station
and the entered numbers flash
Make sure you have entered the right frequency.
If not, press ALT to turn off the display, then
repeat steps 3 and 4 again. If the entered
numbers still flash, the frequency is not used in
your area.
Tips
• If you do not remember the precise frequency, press
TUNING + or TUNING – after entering the value
close to the frequency you want. The receiver
automatically tunes in the station you want. If the
Receiving FM/AM
broadcasts