Sony DHC-MD5 - Manual (Page 25)

DHCMD5 3-858-048-11.EN (1)
25
When you record from this unit’s CD (digital
recording), the track numbers are
automatically marked. In addition, you can
mark track numbers:
• At any point while recording.
• Automatically while analog recording.
Marking track numbers at
a specific point while
recording
You can mark track numbers at any time
while recording, regardless of the type of
sound source.
Press r REC while recording at the
point you want to add a track mark.
The tracks following the added one are
renumbered.
Marking track
numbers
To stop recording
Press π on the MD deck.
When “Rec Level Over” appears
High level signal is input while recording. See
“Troubleshooting” on page 43.
While “TOC” lights up or is flashing
Do not move the deck or pull out the mains lead to
ensure the complete recording. The deck updates
the Table of Contents (TOC) while “TOC” is
flashing.
Note
If you pause recording during CD recording, a track
number is recorded at that point. Also, note that the
tracks are recorded as a single track with a single
track number when:
• a single track of the same CD is recorded
repeatedly.
• two or more tracks with the same track number
from different CDs are recorded continuously.
continued
® ∏ · π §
º ‚
rREC