SpectraLink SVP100 - Manual (Page 13)

SpectraLink Corporation Installation, Configuration, and Administration
NetLink SVP Server (within IP environments)
PN: 72-0178-01-F.doc Page 13
2.10 The Front Panel of the NetLink SVP Server
The NetLink SVP Server’s front panel contains ports to connect to power, the LAN,
and to an administrative computer via an RS-232 port. Status LEDs supply
information about the NetLink SVP Server’s functioning.
RS-232 Port: male DB-9 connector (DTE) used for RS-232 connection to a
terminal, terminal emulator, or modem for system administration.
Link LEDs:
LNKOK : Lit when there is a network connection.
ACT : Lit if there is system activity.
COL : Lit if there are network collisions
.
NETWORK : Port to wired (Ethernet) LAN.
ERROR : Lit when the system has detected an error.
STATUS : Indicate system error messages and status.
1 : Heartbeat, indicates gateway is running.
2 : If active calls.
3 , 4 , 5 : Currently unused.
PWR (power jack): Connects to the AC adapter supplying power to the system.
Use only the SpectraLink-provided Class II AC Adapter with output
24VDC, 1A.
Note that the model designation may be found on the label which is on the side of
the SVP Server.
L
N
K
O
K
A
C
T
C
O
L
Status
E
R
R
O
R
3 4 5 1 2 PWR
NETWORK
RS-232