SpectraLink SVP100 - Manual (Page 18)

SpectraLink Corporation Installation, Configuration, and Administration
NetLink SVP Server (within IP environments)
PN: 72-0178-01-F.doc Page 18
4.3 Network Configuration
The IP address and other network settings are established via the Network
Configuration screen. This is also where you may optionally establish a hostname and
enter the IP address of the location of any software updates you may obtain from
SpectraLink. See section 6, the Software Maintenance section, of this document for
more information about installing software updates via TFTP.
Scroll to
Network Configuration and select by pressing Enter. A screen similar to the
following appears:
Note the navigation options at the bottom of the screen. Press Enter to change a
value, ESC to exit the screen, and the arrow keys to move the cursor.
SendAll
In an IP system with multiple NetLink SVP Servers, the SendAll option is provided
to speed configuration and to ensure identical settings. The S=SendAll option allows
you to send that configuration parameter to every NetLink SVP Server on the LAN.
SendAll can only be used after the IP address is established on EACH NetLink SVP
Server via the serial connection. If you anticipate identical settings across the LAN,
set just the IP address and custom hostname (if desired) for each NetLink SVP
Server using the initial serial connection. Then connect via the LAN and use SendAll
to set identical configuration options for all NetLink SVP Servers.
If
SendAll is to be utilized in your system, all passwords must be identical. DO NOT
CHANGE THE PASSWORD AT THE INITIAL CONFIGURATION IF THE
SendAll OPTION IS DESIRED. Use the default password and change it globally if
desired after a LAN connection is established for all NetLink SVP Servers.
If independent administration of each NetLink SVP Server is desired, the passwords
may be set at initial configuration.