Sharp XG-PH50X - Manual (Page 37)

Connections
-33
Connecting to Video Equipment That Has Component
Output Terminals
When connecting the video equipment that has component output terminals to the INPUT 1
terminal, use the 3 RCA to 15-pin D-sub cable (optional: AN-C3CP2).
When connecting the video equipment that has component output terminals to the INPUT 2
terminals, use the BNC to RCA adapters (commercially available).
Note
• ø3.5 mm stereo minijack to RCA audio cable (commercially available) is required for audio input.
• Select “480P/525P” or “576P/625P” for “Special Modes” on the “Fine Sync” menu, if necessary. (See
page 69 .)
• When you connect video equipment with a 21-pin RGB output (Euro-scart) to the projector, use a com-
mercially available cable that fits in the projector terminal you want to connect.
• The projector does not support RGBC signals via the Euro-scart.
To audio output
terminals
ø3.5 mm stereo minijack to
RCA audio cable
(commercially available)
To component video
output terminals
To INPUT 1
terminal
To AUDIO input (1) terminal
3 RCA to 15-pin D-sub cable
(optional: AN-C3CP2)
Y(green)
P
B
(C
B
)(blue)
P R (C R )(red)
Video Equipment Side view
Side view
To audio output
terminals
ø3.5 mm stereo minijack to RCA audio cable
(commercially available)
To component video
output terminals
Y(green)
P
B
(C
B
)(blue)
P R (C R )(red)
Video Equipment
To AUDIO input (2, 3)
terminal
Component video cable
(commercially available)
To INPUT 2 terminals
(R(P
R )/G/G sync (Y)/B (P B ))
BNC to RCA adaptors
(commercially available)