Senatek HELLODEVICE LITE SERIES LS100 - Manual (Page 26)

26
3.2.2 DHCP Configuration
To make the LS100 work in DHCP mode, just set IP mode to DHCP as in Figure 3-2.
> set ip dhcp
OK
>
Figure 3-2. Setting DHCP mode
3.3 PPPoE
3.3.1 Overview
PPPoE (PPP over Ethernet) is a specification for connecting multiple computer users on an Ethernet
local area network to a remote site through common customer premises equipment, which is the
telephone company's term for a modem and similar devices. PPPoE can be used to have an office or
building-full of users share ADSL, cable modem, or wireless connection to the Internet. Usually, it is
used in broadband Internet access such as ADSL.
To make the LS100 work in PPPoE mode, users should have a PPPoE account and the equipments
for PPPoE access such as an ADSL modem. Since the LS100 provides the PPPoE protocol, it can
access the remote host on the Internet over ADSL connection. It is required to set up the user name
and password of the PPPoE account.
If the IP mode is set to PPPoE, The LS100 negotiates the PPPoE connection with PPPoE server
whenever it boots up. During the negotiation, it receives the information required for Internet
connection such as IP address, gateway, subnet mask and DNS servers. If the connection is
established, the LS100 tries to maintain the connection as long as possible. If the disconnection is
detected, the LS100 will attempt to make a new PPPoE connection by requesting the new connection.
3.3.2 PPPoE Configuration
To make the LS100 work in PPPoE mode, users need to configure the PPPoE username and
password for their ADSL account as in Figure 3-3.
> set ip pppoe pppoeuser pppoepassword
OK
>
Figure 3-3. Setting PPPoE mode