Sherwood SD-860 - Manual (Page 37)

37
To return to the main setup menu screen
• Press the CURSOR button to select the item menu, press the CURSOR / buttons to select “MAIN PAGE” and press
the ENTER button.
Then the main setup menu screen will be displayed.
• When the RETURN button is pressed, the main setup menu screen will be displayed, too.
5
Set other setups to your preference.
4
Press the CURSOR button to select the item menu.
Continued
When selecting the DOLBY PRO LOGIC
• This unit’s built-in Dolby Pro Logic decoder converts 2 channel signals(such as 2 channel Dolby Digital signals of DVD Video
and 2 channel PCM signals of CD, MP3, WMA, DivX) into multichannel(front left, front right, center and surround channel)
signals to which is applied the Dolby Pro Logic surround effect and outputs them from the 5.1CH AUDIO OUTPUT jacks.
Notes :
• When the CENTER SP and SURROUND SP is set to NONE, you cannot enjoy the Dolby Pro Logic surround effect even if the
DOLBY PRO LOGIC is set to ON. (For details, refer to “When selecting the SPEAKER CONFIGURATION” on page 38.)
• Only when the DIGITAL OUT is set to OFF, 2 channel PCM(48kHz/16~24 bit) signals of DVD Video can be converted into
multichannel signals.
• When the DOWNMIX is set to Lt/Rt or Lo/Ro, you cannot select the DOLBY PRO LOGIC.
When selecting the AUDIO DRC
• This function can be activated, while playing the Dolby Digital program sources only.
ON : When turning on the Dolby Pro Logic decoder.
OFF : When turning it off.
DOLBY PRO LOGIC
AUDIO DRC
ON
OFF
1~8 : When adjusting the dynamic range compression as desired.
0 : When turning off the dynamic range compression.
Note: In some Dolby Digital softwares, this function cannot be available.
DIGITAL OUTPUT
DOWNMIX
DOLBY PRO LOGIC
AUDIO DRC
MAIN PAGE
8
7
6
5
4
3
2
1
0
RC
RC RC
2
Press the CURSOR button to select setting menu.
3
Press the CURSOR / buttons to select the preferred setting, then press the ENTER button.
RC
• Each time the CURSOR or button is pressed, the
setting menu or the item menu is selected.
• The selected setting is colored.
• Each time the CURSOR or button is pressed, the
item menu or the setting menu is selected.