Sony TA-VE800G - Manual (Page 17)

17 GB
Preparing and Using the Remote
4
Click “Sony” for a Sony product or OTHER for a
non-Sony product.
If the programme source is a Sony product
The IR codes are programmed automatically and
registration is complete (click RETURN or EXIT).
To take advantage of CONTROL-A1 compatible audio
components, such as multi-disc CD players, click
CONTROL-A1 to select CONTROL-A1.
5
Click the respective programme source.
If the equipment is not a video deck or laser disc
player
Cover the IR sensor on the equipment to prevent
accidental operation during the programming
procedure, click START, then go to step 6.
EXIT
OTHER MAKER
IR CODE SETTING
RETURN
Sony
OUTPUT IR
EXIT
OTHER MAKER
IR CODE SETTING
TAPE
DAT LD
CD
VCR
RETURN
MD
Sony
OUTPUT IR
TUNER
EXIT
OTHER MAKER
IR CODE SETTING
TAPE
DAT LD
CD
VCR
RETURN
MD
Sony
START
OUTPUT IR
TUNER
If the equipment is a video deck or laser disc player:
1 Click START.
A list of other manufacturers appears.
2 Click the manufacturer of the respective equipment
and the IR codes for that programme source are
registered automatically. (If the manufacturer is not
listed, cover the IR sensor on the equipment to
prevent accidental operation during the
programming procedure, click “OTHER”, then go to
step 6).
3 Click TEST.
If the selected programme source turns on, it means
the IR codes have been registered. This ends the
procedure.
If the programme source does not turn on, click the
number button beside the manufacturer’s name to
select another number, then click TEST again. If the
programme source still does not turn on, cover the IR
sensor on the equipment to prevent accidental
operation during the programming procedure, click
“OTHER”, then go to step 6.
When using a video deck from another manufacturer
Check to see if the supplied remote uses -/-- or 1- and 2-
buttons to enter 2 digit programme positions.
Since the -/-- or 1- and 2- codes are not pre-
programmed in this unit, do the following operations to
programme these codes manually.
1 Select the manufacturer (as shown in step 2 above).
2 Click -/-- 2- CODE SET.
3 When “PUSH YOUR COMMANDER” appears on the
TV screen, press the button on your VCR’s remote
that corresponds to the control button highlighted on
the TV screen (see step 6 for details).
EXIT
– / – – 2 – CODE SET
RETURN
OTHER
TEST
VCR MAKER SETTING
PHILIPS
ZENITH HITACHI
SHARP GRUNDIG
SANYO
RCA TOSHIBA
JVC PANASONIC
GE FISHER
AKAI EMERSON
1 2
1 2 1 2 3 4
1 2
1 2
1 2
1 2 3 4
1 2
1 2
MISTUBISHI 1 2 3
(continued)
EXIT
–/–– 2– CODE SETTING
RETURN
PUSH YOUR COMMANDER
CODE CLEAR
2 –
– / ––
CODE
– / ––
2 –
1 –, CODE