Sony TA-VE800G - Manual (Page 8)

8 GB
Getting Started
IR Repeater Hookups
Overview
This section describes how to connect the supplied
extra infrared (IR) repeater to the amplifier. The
repeater emits infrared signals corresponding to those
emitted by the remote controls supplied with the
respective components. Connected this repeater to
obtain additional coverage if you experience difficulty
controlling a certain component using the amplifier’s
on screen display (OSD) control functions, or your
installation prevents the repeater on the front panel
from reaching all of the equipment you need to control.
For the specific location of the terminal, see the
illustration below.
Hookups
Notes
• Use the supplied adhesive tape to secure the IR repeater
so that its front faces the equipment to be controlled.
• If you experience trouble controlling the connected
equipment, the infrared (IR) signals transmitted from the
repeater may not be reaching the infrared receptor on the
respective equipment. In such a case, reposition the IR
repeater closer to that piece of equipment.
IR OUT
Amplifier
IR repeater
IR OUT
Audio Component Hookups
Overview
This section describes how to connect your audio
components to the amplifier.
For specific locations of the jacks, see the illustration
below.
What cords will I need?
Audio cords (not supplied) (1 for each CD player and
turntable; 2 for each tape deck, DAT deck, or MD deck)
Hookups
The arrow ç indicates signal flow.
CD player
Tape deck
DAT/MD
Red (R) Red (R)
White (L) White (L)
CTRL A1
Tape deck Amplifier
L
R
CD
IN
OUTPUT
LINE
L
R
L
R
TAPE
IN REC OUT
OUTPUT
LINE LINE
L
R
INPUT
L
R
DAT/MD
IN REC OUT
OUTPUT
LINE LINE
L
R
INPUT
DAT/MD Amplifier
Amplifier CD player
PHONO
TAPE
TUNER CD DAT/MD