Sony STR-DB2000 - Manual (Page 23)

Ge
tting Star
te
d
23 GB
Adjust the speaker levels and balance while
listening the test tone from your listening
position. Use the remote for the operation.
For details on the remote operation, refer to the
operating instructions supplied with the remote.
Tip
The receiver employs a test tone with a frequency
centered at 800 Hz.
1
Press ?/1 on the remote to turn on the
receiver.
2
Press TEST TONE on the remote.
“TEST TONE” in the LEVEL menu
appears in the display and the test tone is
output from each speaker in sequence.
3
Adjust the speaker level and balance
using the LEVEL menu so that the level
of the test tone sounds the same from
each speaker.
For details on the LEVEL menu settings,
see page 38.
Tips
• To adjust the level of all speakers at the same
time, press MASTER VOL +/– on the remote or
turn MASTER VOLUME –/+ on the receiver.
• You can also use –/+ on the receiver for the
adjustment.
4
Press TEST TONE again.
The test tone turns off.
To output the test tone only from
a specific speaker
Set “TEST TONE” in the LEVEL menu to
“FIX” (page 38). The test tone is output only
from the selected speaker.
For more precise adjustment
You can output the test tone or sound source
from two adjacent speakers to adjust their
balance and level.
Set “MENU EXP.” in the CUSTOMIZE menu
to “ON” (page 40). Then select the two speakers
you want to adjust using “PHASE NOISE” or
“PHASE AUDIO” in the LEVEL menu
(page 43).
6: Adjusting the speaker
levels and balance
— TEST TONE