Sony STR-DB2000 - Manual (Page 44)

44 GB
(Models of area code U, CA only)
This receiver features the custom install modes
described below. Depending on how you intend
to use these features, use of these modes may
require additional equipment (available
separately) or modification of your listening
environment. Please consult the retailer where
you purchased this receiver for more
information.
1
Press MAIN MENU to select “CIS”.
2
Rotate MENU to select the parameter.
For details, see “CIS menu parameters”
below.
3
Rotate –/+ to select the setting you
want.
4
Repeat steps 2 and 3 to adjust the other
items.
CIS menu parameters
Initial settings are underlined.
x ZONE (2nd zone source)
Lets you select the source signals (analog audio
signals) you want to output in the 2nd zone (audio
inputs except PHONO). When you select “SOURCE”,
the signals of the current input is output.
Tips
• Only signals from components connected to the
analog input jacks are output through the 2ND ZONE
jacks. No signal is output from components
connected to only the digital input jacks.
• When “SOURCE” is selected, the signals input to the
MULTI CHANNEL INPUT jacks are not output
from the 2ND ZONE jacks even when MULTI CH
IN function is used. The 2 channel analog audio
signals of the current input is output.
x INST. MODE (RS232C control)
• ON
The receiver can receive commands from the
RS232C port even when the power is off (standby
mode).
• OFF
The receiver does not receive commands from the
RS232C port when the power is off (standby mode).
x 12V TRIG (12 V trigger)
Lets you turn on or off the external equipment by
outputting 12V trigger when the receiver is turned on
or off. For example, you can automatically unroll your
video screen when you turn on the receiver.
• OFF
Lets you turn off output of 12V triggers even when
the main receiver is turned on.
• ZONE
Lets you turn on output of 12V triggers when the
main receiver is turned on.
• CTRL
Lets you turn on or off the output of 12V triggers
manually by the CIS command of the IR remote or
RS232C control.
• INPUT
Lets you turn on output of 12V triggers when the
main receiver is turned on, depending on the setting
of each input. See “To set the 12V trigger setting for
each input”.
To set the 12V trigger setting for
each input
The initial setting is “ON” for VIDEO 1,
VIDEO 2, VIDEO 3, DVD, and TV/SAT, and
“OFF” for other inputs. To set this setting, you
can use only the controls on the front panel.
1
Select “INPUT” in “12V TRIG”.
2
Press MEMORY/ENTER.
3
Rotate MENU to select the input.
4
Rotate –/+ to select “ON” to activate 12V
trigger or select “OFF” to disactivate.
5
Press MEMORY/ENTER.
Custom install mode