Sony CDP-D11 - Manual (Page 4)

Preparations
4
In the beginning
Check that the following accessories are packed.
•
Remote control RM-DS11 (1)
•
Batteries size AA (R6) (2)
•
Connection cord for control S (1)
If any accessory is missing, contact the shop where
you purchased.
Inserting batteries into the remote
control
Insert two R6 (size AA) batteries (supplied) with ‘
and ’ directions correctly.
z
These batteries hold out for about 6 months.
The operational distance from the remote control
decreases when the batteries are consumed. In this
case replace the batteries with new ones.
èÄîı Preparations
CONNECTION
The CD player can be connected with a mixer, an MD
recorder or a DAT recorder, etc. Before connection,
make sure to turn off each equipment.
Notes
•
Incorrect use of the batteries may causes an electrolyte
leakage or a explosion. Keep the following.
– Insert the batteries with
‘ and ’ directions correctly.
– Do not mix new batteries with old ones or not mix
different type of batteries.
– Do not charge the batteries.
– When the remote control is not going to be used for an
extended period of time, remove the batteries.
– In the event of electrolyte leakage, wipe out inside the
compartment and insert new batteries.
•
Keep the remote sensor from direct sunlight or strong
illumination. If it is exposed to them, the remote control
may not work.
To a wall outlet
Digital audio
equipment (MD, DAT)
: Flow of the signals
Supplied remote control
or control equipment
Mixer
Control equipment
Mixer
Control equipment
CDP-D11
REMOTE
RS-232C REMOTE
PARALLEL
DIGITAL OUT
ANALOG OUT
(BAL)
OUTPUT LEVEL ANALOG OUT
(UNBAL) CTRL-S RELAY
OUT/IN