Sharp Aquos LC 45D40U - Manual (Page 21)

20
Basic adjustment settings
Press MENU and the MENU screen displays.
Press c/d to select “Setup”.
Press a/b to select “EZ Setup”, and then
press ENTER.
• If you already set the Secret No., go to step 4. If
not, skip to step 5.
Input the 4-digit secret number by using 0–9.
Press a/b to select the desired language
listed on the screen, and then press ENTER.
Press c/d to select “Air” or “Cable”.
Press
ENTER to enter the setting.
Antenna setting
Make sure what kind of connection is made with your
TV when selecting “Air” or “Cable”.
Channel search
Channel auto search makes the TV look for all channels
viewable in the set area.
NOTE
• If no channel is found, confirm the type of connection made
with your TV and try EZ Setup again.
EZ Setup
You can run EZ Setup again, even after setting up the
preset channels.
Language setting
Select from among 3 languages: English, French and
Spanish.
Channel Setup
If initial setup does not memorize all the channels in
your region, follow the instructions below to manually
memorize the channels.
Antenna setting
Press MENU and the MENU screen displays.
Press c/d to select “Setup”.
Press a/b to select “CH Setup”, and then
press ENTER.
• If you already set the Secret No., input the
4-digit secret number here. See page 38 for
setting a secret number.
Press c/d to select “Air” or “Cable”.
Press
ENTER to enter the setting.
Press a/b to select “Air/Cable”, and then
press ENTER.
Channel search
Channel auto search makes the TV look for all channels
viewable in the set area.
Repeat steps 1 to 3 in Antenna setting in
Channel Setup.
Press a/b to select “CH Search”, and then
press ENTER.
NOTE
• If no channel is found, confirm the type of connection made
with your TV and try channel search again.
1
2
3
4
5
6
7
1
2
3
4
5
1
2
Press c/d to select “Yes” for AIR Analog &
Digital, then press b to move down.
Press c/d to select “Yes” or “No” for
CABLE Analog, then press b to move down.
Press c/d to select “Yes” or “No” for
CABLE Analog & Digital, then press b to
move down.
Select “Search Start”, and then press
ENTER.
• If you are only receiving an analog signal through
the cable, select “Yes” for CABLE Analog. If you
are receiving both an analog signal and a digital
signal through the cable, select “Yes” for CABLE
Analog & Digital.
Press c/d to select “Yes” for AIR Analog &
Digital, then press b to move down.
Press c/d to select “Yes” or “No” for
CABLE Analog, then press b to move down.
Press c/d to select “Yes” or “No” for
CABLE Analog & Digital, then press b to
move down.
Select “Search Start”, and then press
ENTER.
• If you are only receiving an analog signal through
the cable, select “Yes” for CABLE Analog. If you
are receiving both an analog signal and a digital
signal through the cable, select “Yes” for CABLE
Analog & Digital.
3
Press MENU to exit. 8
Press MENU to exit. 4
Press MENU to exit. 6
D40U_en_c.indd 20 2006/01/23 11:24:04