Symantec Critical System - Manual (Page 105)

105 Migrating to the latest version
Migrating other legacy agent installations
To specify the management server list for an agent
1 At a command prompt, locate the folder that contains the agent config tool,
and then navigate to that directory.
2 At a command prompt, type
sisipsconfig -host
(Windows) or
sisipsconfig.sh -host
(UNIX), followed by a comma-separated list of
server host names or IP addresses, and then press Enter.
Migrating other legacy agent installations
You can migrate legacy software agent installations for the following software:
■ Symantec Intruder Alert™ 3.6 and higher
■ Symantec Host Intrusion Detection System (Symantec Host IDS) 4.0 and
higher
Agent software migration is straightforward. When you install Symantec
Critical System Protection agents, the installation kit automatically detects
legacy agents, uninstalls the legacy software, and installs the latest version.
Note: You cannot migrate server or management software. If an agent runs on a
computer that also runs a legacy server or manager, you must first uninstall the
legacy software before you migrate the agent.
You can migrate legacy customized detection policy files for the following
software:
■ Symantec Intruder Alert 3.6 and higher
■ Symantec Host IDS 4.1 and higher
It is not necessary to migrate uncustomized stock policy files. The new stock
policy files are migrated for you.
-test To test first server in list (default):
■ Windows: sisipsconfig -t
■ UNIX: sisipsconfig.sh -t
To test nth server in list:
■ Windows: sisipsconfig -t n
■ UNIX: sisipsconfig.sh -t n
Test the connection information for a server in the
management server list.
Table 5-1 Agent config tool commands
Command Syntax Description