Symantec Critical System - Manual (Page 32)

32 Installing Symantec Critical System Protection on Windows
About installing Symantec Critical System Protection on Windows
About installing Symantec Critical System
Protection on Windows
If this is a first-time installation, you should install, configure, and test
Symantec Critical System Protection components in a test environment.
You should install the Symantec Critical System Protection in the order listed:
■ Management server
■ Management console
■ Agent
You can install the management console and management server on the same
computer or on separate computers. You can install agents on any computer. All
computers must run a supported operating system.
The management server and management console are supported on Windows
operating system.
Note: The installation directory names for the management console and
management server must contain printable ASCII characters only. Multi-byte,
double-byte, hi-ASCII and non-printable ASCII characters are not supported.
About port number mapping
When you install the Symantec Critical System Protection components, you
must specify port numbers through which the components communicate. In a
few instances, these port numbers must match.
Table 3-1 shows the Symantec Critical System Protection component port
numbers that must match.
Table 3-1 Port number mapping
Management server Management console Agent
Agent Port Agent Port
Console Port Port
Web server
Administration Port Admin Port