Symantec Critical System - Manual (Page 45)

45 Installing Symantec Critical System Protection on Windows
Installing the management server
3 In the License Agreement panel, select I accept the terms in the license
agreement, and then click Next.
4 In the Installation Type panel, click Evaluation Installation, then click Use
an Existing MS SQL Instance, and then click Next.
5 In the Destination Folder panel, change the folder if necessary, and then
click Next.
The directory name must contain printable ASCII characters only. Multi-
byte, double-byte, hi-ASCII and non-printable ASCII characters are not
supported.
6 In the Server Configuration panel, accept or type new port values, and then
click Next.
If you enter port numbers that are in use, error messages appear until you
enter port numbers that are not in use.
7 In the Database Selection panel, specify the database parameters, and then
click Next.
8 In the Ready to Install the Program panel, click Install.
9 When the InstallShield Wizard Completed panel appears, click Finish.
Installing production installation with Tomcat and database schema
This production installation option installs Tomcat and creates the database
schema. The option installs the management server with a local or remote
production database on SQL Server.
Before performing the installation, you should note the following:
■ Your SQL Server instance must exist and be running before you start the
installation.
■ The sa account must already exist and you must provide the accurate
password for the sa account during the management server installation.
Host Name Type the IP address or fully qualified domain name of the
SQL Server.
Database Instance Type the name of the existing SQL Server instance on which
you want to install the database.
sa Privileged User Accept or change the sa user name.
Password
Confirm Password Type the same password that is used on the SQL Server, type
the password again to confirm.