Symantec Critical System - Manual (Page 97)

97 Installing UNIX agents
Disabling and enabling UNIX agents
rcsisidsagent:23456789:wait:/etc/rc.sisidsagent start >/dev/
console 2>&1
3 Type and run the following commands to restart the agents:
/sbin/init.d//sisipsagent start
/sbin/init.d//sisidsagent start
Disabling and enabling Tru64 agents
This section describes how to disable and enable Tru64 agents.
Temporarily disabling Tru64 agents
Warning: You should perform these procedures only in emergency situations.
To temporarily disable Tru64 agents
1 Open a Terminal window and become superuser.
2 Type and run the following commands:
/sbin/init.d/sisipsagent stop
/sbin/init.d/sisidsagent stop
Permanently disabling Tru64 agents
If you have performance issues with Tru64 agents, you may need to
permanently disable them.
Warning: You should perform these procedures only in emergency situations.
To permanently disable Tru64 agents
1 Open a Terminal window and become superuser.
2 Type and run the following commands:
/sbin/init.d/sisipsagent stop
/sbin/init.d/sisidsagent stop
3 Type and run the following commands to rename the agent scripts, which
temporarily break any symbolic links in the rc#.d startup scripts:
If the machine is a member of a TruCluster, and the agent is installed on
multiple cluster members (with a shared physical disk), perform the
following actions to disable the agent on a single cluster:
cd /cluster/members/\{memb\}/sbin/init.d/