Siemens PC 670 - Manual (Page 91)

Configuring the Computing Unit in BIOS Setup Release 04/02
5-3 Panel PC 670 Computing Unit, Equipment Manual
Screen Display Following Power On
For example, the default setting of your computing unit will display the following
figure on the display on power on:
Phoenix BIOS 4.0 A5E00123801–ES02
Copyright 1985-2001 Phoenix Technologies Ltd.
All Rights Reserved.
SIMATIC Box PC 620 V02.01.02
CPU = Pentium[III 866MHz
637K System RAM Passed
119MB Extended RAM Passed
0128K Cache SRAM Passed
System BIOS shadowed
Video BIOS shadowed
UMB upper limit segment address: ....
Fixed Disk 0: xxxx
ATAPI CD-ROM: Txxx
Mouse initialized
Press to enter SETUP
By pressing the F2 key when the above figure is displayed you will change to the
BIOS Setup program based on the ROM. In this program, you can set a number of
system functions and hardware configurations of your programming device.
The default settings are effective on delivery. You can change these settings using
the BIOS setup. The modified settings become effective when you have saved
them and terminated the BIOS setup.
The following screen shots may differ from what is shown here, depending on the
device configuration.