Seiko Instruments DPU-S445 - Manual (Page 29)

- 25 -
FEED, POWER, FEED, POWER, FEED, FEED, FEED, FEED, POWER.
(2) When the switches are pressed eight times (for eight bits), the following
message is printed.
DIP SW-1=******** Save Setting? Yes: Feed SW / No: Power SW
When the FEED switch is pressed, the message shown at the following is
printed, and the setting is saved.
DIP SW-1=******** Saved.
When you press the POWER switch instead of the FEED switch, the message
shown at the following is printed and the setting is not changed.
DIP SW-1 Not Changed.
After this operation, you can select the next DIP switch (operation 1).
After setting DIP switch 4, you can exit function setting mode (operation 3).
HINT
• "********" in the message indicates the setting of the DIP switch. The
leftmost bit is the most significant bit (bit 8) and the rightmost bit is the
least significant bit (bit 1).
Operation 3: Exiting function setting mode
If you press the FEED switch when the message shown at the following is
printed, you can return to operation (1) and set DIP switch 1 again.
DIP Switch setting mode. Continue: Feed SW / Quit: Power SW
If you press the POWER switch, the message shown at the following is printed.
The printer leaves the function setting mode and turns off. The function setting is
now complete.
Setting Mode Finished.
HINT
• You can confirm the settings by performing test printing after the function
setting.