Seiko Instruments DPU-S445 - Manual (Page 38)

- 34 -
HINT
• The printer can print or receive data while it is recharging the battery
pack, too. While printing or receiving data, the POWER lamp lights
continuously and the printer pauses to recharge. The printer recharges
the battery again after printing and receiving data are completed.
• To stop recharging, press the POWER switch. The printer will turn off.
To recharge the battery pack again, repeat the steps shown in (5).
• The battery pack should be recharged at 32 to 95°F (0 to 35°C) for
optimum performance.
• If the Auto Activation by AC function is enabled, the printer turns on
automatically when the AC cable of the AC adapter inserts to the outlet.
See Section 6 Function Setting for details on settings.
Recharging with Specified Battery Charger
(1) Connect the AC cable to the battery charger.
(2) Plug the AC plug of the AC cable to the outlet.
(3) Install a battery pack in the battery charger. Make sure that electrodes of the
battery pack contact the terminals of the metal on the battery charger.
(4) The battery charger CHARGE lamp (red) will light and the battery charger will start
recharging.
(5) When the CHARGE lamp turns its lamp to green color, the battery pack is
sufficiently recharged.
(6) When recharging is complete, remove the battery pack.
(7) Unplug the AC plug of the AC cable to the outlet.
AC cable
Battery charger
Battery pack