Smeg LB30AFNF - Manual (Page 10)

27
2. Insert the hinge base into the hinges (two spots). (See Figure 1)
(If the thickness of the furniture is 20mm, do not install the hinge base .)
3. Tilt backward the refrigerator and loosely fix the height adjusting bracket at the bottom
(two spots) of the refrigerator door by using the hinge screws as shown at the figure.
4. Put out the power cord through the hole at the rear side of the furniture.
When installing the product, make sure that the cord is
placed at the rear holder not to be extended on the
refrigerator floor. It may damage the cord to cause fire.
5. Align the end of the hinge base to the front of
the furniture and place the refrigerator into the
furniture.
When placing the refrigerator into the furniture, be careful
of squeezing hands.
Furniture
Hinge
Hinge base
Front side of
the furniture
(Figure 1)
The top of the furniture (floor view)
6. Procedure to install
1) Preparing before installing the refrigerator
2) Case related work after placing the refrigerator
e
e
2
3
3
2