Smeg LB30AFNF - Manual (Page 45)

53
Care and Maintenance
Indoor lamp
Caution
How to disassemble each
component
Disconnect the power plug or turn off the main power
before disassembling.
-
Insert the fingers into the
inside slot of the top cover
and pull out it to remove.
-
Push the upper part of the
middle cover and pull out
it to remove.
- Turn counterclockwise the
indoor lamp to
disassemble.
-
Use the 240V 30W bulb for the refrigerator as indoor
lamp.
-
Because the indoor lamp is consumable, when the
indoor lamp is not turned on, purchase it from the LG
Electronics Service Center and directly replace it to use.
It can be possible to disassemble only when the door is
opened by 90° or wider. Disassembling should be done by
the reverse order of assembling.
1
2
Note • Lamp capacity is MAX 30W.
• The lamp will remain “ON” for 7minutes if the door
is left open and then it is “OFF” for safety. (If you
reopen the door, the lamp is “On”.)
• You must check the O-RING, which is made by rubber
and prevent electric spark.
• Don’t touch the lamp, in case of light on the long
time. Because it can be very hot.