Sanyo DMP-692 - Manual (Page 12)

11
REMOTE CONTROL
Using The Remote Control
The CR2032 lithium battery is already installed in the remote control. Pull out the small
mylar insulation tab as shown in the illustration to begin using the remote control.
To use the remote controller, point the remote control transmitter on the remote control toward
the remote control receiver on the front panel of the main unit and press the desired button.
The effective range of the remote controller is approximately 20 feet. Please note that bright
sunlight or artificial light may interfere with the proper operation of the remote control.
Battery Replacement
When the remote operation becomes weak or intermittent, it is time to replace the remote
control battery. Pull out the battery holder, remove the old battery and install a new CR2032
battery in the holder as shown in the illustration. Slide the holder back into the remote control.
NOTE: If the battery is installed incorrectly the remote control will not work.
1 .
2 .
3 .
4 .
5 .
6 .
7 .
8 .
9 .
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
21.
22.
STANDBY/ON Button
MUTE Button
VOLUME Button
FM ST/MO Button
DBBS Button
SLEEP Button
TIME SET / MEMORY Button
PRESET / MENU - Button
MENU Button
TUNE / SKIP Button
ENTER Button
iPod SELECT Button
PLAY/PAUSE / Button
SNOOZE / DIMMER Button
VOLUME Button
EQ Button
ALM 2 Button
ALM 1 Button
PRESET / MENU + Button
TUNE / SKIP Button
MODE Button
2
3
4
5
6
7
8
9
10
1 1
2 1
3 1
4 1
5 1
6 1
7 1
8 1
9 1
20
1 2
2 2
PU
L
L
1
Remote Control Transmitter
DMP-692
PRESET / MENU