Sanyo DMP-692 - Manual (Page 22)

Press and hold the ALM 1 button on remote control or touch
and hold the ALM 1 control on top panel, while the system is
in the standby mode, the default alarm time (AM6:00) and the
default alarm mode (iPod) begin flashing in the display.
Continue holding the ALM 1 button until only the HOUR digits
are flashing.
Press the or buttons on the remote control or touch the
TUNE/SKIP or control on the top panel repeatedly to set
the display to the desired wake-up Hour, AM or PM.
Press the ALM 1 button again. The Hour digits stop flashing
and the Minute digits begin flashing.
Press the or buttons on the remote control or touch the
TUNE/SKIP or control on the top panel repeatedly to set
the display to the desired wake up minutes.
Press the ALM 1 button once more to select the wake-up
Alarm Mode (iPod, Radio or Buzzer). One of the 3 Alarm Mode
indicators will be flashing in the display. Press the or
buttons on the remote control or touch the TUNE/SKIP or
control on the top panel repeatedly to select the desired wake
up mode, iPod, Radio, or Buzzer (BUZZ)
Press the ALM 1 button once more. If you selected either the
iPod or Radio Alarm Mode, the Volume Level indicator begins
flashing. Press the or buttons on the remote control or
touch the TUNE/SKIP or control on the top panel – not the
Volume / buttons - repeatedly to set the desired wake
up volume level. Note: if you selected the wake up to Buzzer
alarm mode the volume level is fixed and cannot be adjusted.
When all settings are completed press the ALM 1 button once
more to exit the setting mode and activate Alarm 1. The
display will continue to show all of your alarm settings for a few
seconds and then return to the current time. However the
Alarm 1 indicator ( ) will remain in the display to confirm that
the alarm is active.
ALARM SETTING
21
NOTES:
• Use the Remote Control, you can set the Alarms in STANDBY mode or operation mode.
(The ALM1/ALM2 on the top panel can only be set when the system is in the standby mode.)
• When setting the alarm be sure to observe the AM/PM indicators to confirm that you have
set the wake-up hour correctly.
• The procedure for setting Alarm 1 and Alarm 2 is the same. The example below is for Alarm 1.
1).
2).
3).
4).
5).
6).
7).