Sanyo DMP-692 - Manual (Page 17)

RADIO OPERATION
16
Press the STANDBY/ON button on the top panel or on the
remote control to turn the system ‘On’. The initial default
Mode for this system is the iPod function. The “iPod
® ”
indicator will flash above the time display.
Touch the MODE button on the top panel or press the
MODE button on the remote control until a FM or AM
frequency appears above the time display.
Tune to the desired station as follows:
Automatic Tuning
Press and hold the / buttons on the remote control or touch the TUNE/SKIP /
buttons on the top panel until the frequency display starts to change, then release the
buttons. The Tuner will search up or down the band for the next strong signal and stop
on that station.
Manual Tuning
Repeatedly press the / buttons on the remote control or touch the TUNE/SKIP
/ buttons on the top panel until the display shows the frequency of the desired
station. Note: Use the Manual Tuning method to tune to stations with weaker signals
that may be bypassed during Automatic Tuning.
If you tuned to a FM Stereo station the Stereo (ST)
indicator will appear in the display. If FM stereo reception
is noisy or weak, press the FM ST/MO button on the remote
control to select the FM Mono mode. This will usually
improve the reception but the sound will no longer be in
stereo.
When you finished listening press the STANDBY/ON button on the top panel or on the
remote control to turn the system ‘Off’. The radio station frequency disappears from the
display.
1.)
2.)
3.)
4.)
5.)