SVAT Electronics CV0204DVR - Manual (Page 46)

CV0204DVR 43
7.2.3.2 DHCP
The “DHCP” is automatically set as the default network setting of the Network DVR. When a
Network DVR is connected into the LAN, it will issue DHCP packets to request an IP address
that is dynamically assigned by the DHCP server. If it is unable to get a DHCP address, the
Network DVR will assign a default IP address such as “169.254.1.13”.
7.2.3.3 CONNECT TO ADSL BY PPPOE MODE
To setup follow the steps below:
1. After setup, rebooting enables automatic connection to ADSL.
2. Enter the “User name” and “Password” fields with the account and password
provided by the ISP.
3. If item “Send mail after connected” is selected, the mail will be automatically sent
when connected to the ISP.
4. Click “OK” button to save the settings.
Note: In order to activate the PPPoE, it is necessary to reboot the device after the setup.
ADSL Setting Display
If the Network DVR and ADSL modem are connected by a hub, the user can select “Dial On
Power Up” to perform the connect operation. However, if the Network DVR and ADSL modem
are connected directly, then please note the following steps below.
1. Power off Network DVR.
2. Connect Network DVR directly to the ADSL modem (using RJ-45 Ethernet port).
3. Power-up Network DVR.
4. Network DVR will start dialing.
5. Once connected, mail the IP address information to the preset e-mail address.
6. After 10 times of connection failure, it aborts the operation and the user can
reconnect it by LAN to find the cause.
SVAT ELECTRONICS
Now You Can See