SVAT Electronics CV0204DVR - Manual (Page 50)

CV0204DVR 47
8. TROUBLESHOOTING
Problem Solution
No display on television
1. Make sure all RCA and power cables are
plugged in securely and in their proper places.
2. Make sure your television is on the correct
channel (input mode).
DVR not recording
1. Make sure recording is enabled in each
camera’s setting. Go to Menu>Camera
Setup>Camera Setting and enable recording
for each camera if it has been disabled.
2. Make sure recording is enabled and set to the
correct recording setting in scheduled
recording. Go to Menu>Record Setup>Record
Mode. If a line (-) is over any hour of the day,
that means recording is disabled for that time
period. Press enter to enable recording for that
hour. Also make sure you press REC when
you return to Monitoring Mode, or your
scheduled recording will not take effect.
3. Your disk may be full. By default the DVR
should start rewriting over your earliest
recorded files, but this option may be disabled.
Go to Menu>Hard Drive Setup>Disk Full. Set it
to OVERWRITE.
4. Make sure your DVR is in Monitoring Mode,
and not at a menu screen or in Playback Mode.
No playback
1. There is a delay while the DVR searches for
your recorded files. Wait a few moments and
your files should appear.
2. Make sure you are not in Recording Mode.
Pressing PLAY during recording will have no
effect. Press STOP first.
3. If you have just formatted your drive or your
drive is otherwise empty, there will be no files
to play back.
During playback, I can’t switch to
different camera views.
To switch between cameras during playback, you must
have recorded your file in EACH mode. Change this
setting using Menu>Record Setup>Record Type.
SVAT ELECTRONICS
Now You Can See