Sharp AL-1655CS - Manual (Page 18)

16
POWER ON AND OFF
The power switch is located on the left side of the machine.
Power on
Turn the power switch to the "ON" position.
The ready indicator will light up and other
indicators which show the initial settings of the
display will also light up to indicate the ready
condition. For the initial settings, see the
"Initial settings" (below).
You can select copy settings and press the [START] key ( ) after the power
switch is turned on. Copying will start automatically.
Language setting
The first time the power is turned on after shipment from the factory, a message will
appear in the display asking you to select the language. Select the language with the
[
] key ( ) or [ ] key ( ) and then press the [ENTER] key.
The language can also be changed in the user programs. (p.67)
Initial settings
The machine reverts to the initial settings when it is first turned on, when the [CLEAR
ALL] key (
) is pressed, or when no keys are pressed for the preset "AUTO
CLEAR" time following the end of a copy job. When the machine reverts to the initial
settings, all settings and functions selected to that point are canceled. The "AUTO
CLEAR" can be changed in the user programs. (p.64)
If you use the machine in a country other than the country
where the machine was purchased, you will need to make sure
that your local power supply is compatible with your model. If
you plug the machine into an incompatible power supply,
irreparable damage to the machine will result.
Only insert the power cord into a properly grounded wall socket.
Do not use extension cords or power strips.
Copy ratio: 100%, Exposure: Automatic, Copy quantity: 0
All special copier modes: Off, Paper tray: Tray 1 (Upper paper tray)
Warning
Caution
The main screen of copy mode appears.
READY TO COPY.
100% 8.5x11 0
When in the copy mode
AL-1655CS.book 16 ページ ２００４年８月２２日 日曜日 午後６時４４分