Sharp AL-1655CS - Manual (Page 87)

85
8
TD CARTRIDGE REPLACEMENT
When toner is low, the error indicator will light up and "TD CARTRIDGE IS NEAR
EMPTY." will appear in the display. For information on purchasing a new TD
cartridge, see "ABOUT SUPPLIES AND OPTIONS" (p.92). If copying is continued
while the indicator is lit, copies will gradually become lighter until the toner runs out.
When the toner runs out, the machine will stop operating, the error indicator will
blink, and "REPLACE THE TD CARTRIDGE" will appear in the display. Follow the
procedure below to replace the TD cartridge.
1 Open the bypass tray, and then open
the side cover while pressing the side
cover open button.
2 Push gently on both sides of the front
cover to open the cover.
3 Gently pull the TD cartridge out while
pressing the lock release button.
• After the machine stops, it may be possible to make a few more
copies by taking the TD cartridge out of the machine, shaking it
horizontally, then reinstalling it. If copying is not possible after this
operation, replace the TD cartridge.
• During a long copy run of a dark original, "TONER
REPLENISHMENT IN PROGRESS" appears in the display, and the
machine may stop even though toner is left. The machine will feed
toner up to 2 minutes and then the ready indicator will light up. Press
the [START] key (
) to resume copying.
• After removing the TD cartridge, do not shake it or tap on it. Doing so
may cause toner to leak from the cartridge. Put the old cartridge
immediately in the bag contained in the box of the new cartridge.
• Dispose of the old TD cartridge in accordance with local regulations.
Note
Lock release button
Caution
AL-1655CS.book 85 ページ ２００４年８月２２日 日曜日 午後６時４４分