Sony ICD-UX300F - Manual (Page 52)

52 GB
2
Press v or V on the control button to
select “Beep&Play,” “Beep” or “Play,”
then press
N /ENT.
3
Press x STOP to exit the menu mode.
When the set date and time
comes
At the set time, “Alarm” is displayed in the
display window and the alarm and the
selected message will be played back using
the selected alarm pattern.
When the playback ends, the IC recorder
will stop automatically. (When the alarm
pattern is set to “Beep&Play” or “Play,” the
IC recorder will stop at the beginning of the
selected message.)
To listen to the same message
again
Press N /ENT, and the same message will
be played back from the beginning.
To stop the alarm playback
Press any button other than VOL +/– while
the alarm sound is heard. If the HOLD
function is activated, you can stop the alarm
playback by pressing any button.
P Notes
• You can set only one alarm each one
message.
• When the clock has not been set or no
messages are recorded, you cannot set the
alarm.
• The alarm sounds even if you set “Beep” to
“ OFF ” in the menu (page 80).
• If the alarm time comes during recording,
the alarm will sound after the recording is
finished. “,” will flash when the alarm time
comes.
• If the alarm time comes while you are
updating data, the alarm will be cancelled
automatically.
• If more than one alarm time comes, only the
first message will be played back with an
alarm.
• Once the alarm is set, the alarm will not be
cancelled, even after the message is played
back.
• If the alarm time comes while another
message is being played back with an alarm,
the payback stops and the new message will
be played back.
• If you divide a message you have set an
alarm for, the alarm setting remains on only
the first part of the divided message.
• If you delete a message on which you have
set an alarm, that alarm will be also
cancelled.