Sony PCS-1P - Manual (Page 60)

2-30
PCS-1/PCS-1P
For loading of application
1. Display a service menu.
2. Insert the Memory Stick, in which the application
software of the version to be loaded is recorded, into a
Memory Stick slot.
3. Select “Load application” using
↑
,
↓
,
←
, and
→
buttons of a remote controller and press the decide
button.
4. A confirmation message on whether to execute is
displayed.
5. To execute, select “OK” and press the decide button.
The screen display during loader execution then
appears. After completion, a launcher menu is
displayed. To cancel execution, select “Cancel” and
press the decide button. The current display returns to
a service menu.
6. Push in the Memory Stick once and take out it.
n
Do not turn off the power or take out a Memory Stick until
the launcher menu is displayed.
For command input
1. Display a service menu.
2. Select “Command” using
↑
,
↓
,
←
, and
→
buttons of a
remote controller and press the decide button.
A key guidance is then displayed.
3. Enter the commands in a command list from a remote
controller.
m
. To set two or more commands, put a one-character
blank between the commands and then enter them.
. Set only one type of LAN interface. If not, the LAN
interface does not operate normally.
4. Select “Save” using
↑
,
↓
,
←
, and
→
buttons of a
remote controller and press the decide button.
A set menu is then displayed.
5. When a LAN interface is set (including the case where
the setting is returned to the initial value), restart the
main unit using the power switch of a communication
terminal.
To stop setting
Select “Cancel” using
↑
,
↓
,
←
, and
→
buttons of a remote
controller and press the decide button, or press the return
button of a remote controller.
n
Do not enter commands other than shown in a command
list. The internal operation mode may be changed in this
case.
Command
100F
100H
10F
10H
TOS1 to
TOS255
Blank (The
input value
above is
cleared.)
Contents
Sets a LAN interface to the 100BASE
full-duplex mode.
Sets a LAN interface to the 100BASE
half-duplex mode.
Sets a LAN interface to the 10BASE full-
duplex mode.
Sets a LAN interface to the 10BASE
half-duplex mode.
Sets the Type Of Service (TOS) bit value
to a transmission packet.
Consult the network administrator for
the set value.
Set using an initial value.
The LAN interface mode is Auto
Negotiation.
Reception packet loss indicator
display ON
TOS0
Contents of functions
1) Commands
The internal operation mode of the main unit is
changed for a test and service.
Command list
m
. To set two or more commands, put a one-character blank
between the commands.
. Set only one type of LAN interface. If not, the LAN
interface does not operate normally.
. The enabled command can be confirmed in a command
column at all times.
. Do not enter commands other than shown in a command
list. The internal operation mode may be changed in this
case.