Sony HT DDW1600 - Manual (Page 36)

36 GB
7: Adjusting the speaker
levels and balance
(TEST TONE)
You can adjust the speaker levels and balance
while listening to the test tone from your
listening position.
Tip
The receiver employs a test tone with a frequency
centered at 800 Hz.
1
Press AMP MENU.
“1-LEVEL” appears on the display.
2
Press or b to enter the
menu.
3
Press V/v repeatedly to select
“T. TONE”.
4
Press or b to enter the
parameter.
5
Press V/v repeatedly to select
“T. TONE Y”.
The test tone is output from each speaker
in sequence as follows:
Front left
t Center t Front right t
Surround right t Surround back t
Surround left t Sub woofer
6
Adjust the speaker levels and
balance using the LEVEL menu
so that the level of the test tone
sounds the same from each
speaker.
For details, see “Adjusting the level
(LEVEL menu)” (page 44).
Tips
• To adjust the level of all speakers at the same
time, press MASTER VOL +/–. You can also
use MASTER VOLUME on the receiver.
• The adjusted value are shown on the display
during adjustment.
7
Repeat steps 1 to 5 to select
“T. TONE N”.
You can also press any input buttons.
The test tone turns off.
When a test tone is not output
from the speakers
• The speaker cords may not be connected
securely.
• The speaker cords may have the short-circuit
problem.
1 2 3
4 6
7 8
0/10 ENTER
9
2CH A.F.D.
RETURN/EXIT
TV CH –
PRESET –
TV CH +
PRESET + REPLAY ADVANCE
MENU
MOVIE MUSIC
MEMORY DVD MENU
FM MODE CLEAR
TOOLS DISPLAY MUTING
TV VOL
MASTER VOL
AUTO CAL
D.TUNING
D.SKIP
AMP MENU
-
F
G g
f
. < < >
5
>10/
2-5
1
MASTER
VOL +/–