Sharp XG-V10XU - Manual (Page 56)

E-55
Basic Operation
Selecting the Economy Mode
(GUI) On-screen Display
Projector Remote Control These functions allow you to reduce the power
consumption when the projector is in standby mode.
Monitor Out/RS-232C Off Function
This projector consumes power when using a monitor
connected to the OUTPUT port for INPUT 1, 2 and a
computer connected to the RS-232C port. When not
using these ports, “MNTR Out/RS232C” can be set to
“
” to reduce standby power consumption.
Description of Monitor Out/RS-232C Off
(Slide the MOUSE/ADJUSTMENT switch
on the remote control to the ADJ. position.)
1 Press MENU.
2 Press ß/© to select “Options (1)”.
3 Press ∂/ƒ to select “MNTR Out/RS232C”.
4 Press ß/© to select “ ” or “ ”.
5 To exit from the GUI, press MENU.
CAUTION
• Set “MNTR Out/RS232C” to “ ” when using the Sharp
Advanced Presentation Software (supplied).
1.2.3 4.5.6
1, 5
2, 3, 4
On-screen Display
(GUI) On-screen Display
Automatic Power Shutoff Function
When no input signal is detected for more than 15
minutes, the projector will automatically shut off. The
on-screen message on the left will appear five minutes
before the power is automatically turned off.
Description of Automatic Power Shutoff
(Slide the MOUSE/ADJUSTMENT switch
on the remote control to the ADJ. position.)
1 Press MENU.
2 Press ß/© to select “Options (1)”.
3 Press ∂/ƒ to select “Auto Power Off”.
4 Press ß/© to select “ ” or “ ”.
5 To exit from the GUI, press MENU.
• “MNTR Out/RS232C” is factory preset to “ ”, and “Auto
Power Off” is factory preset to “ ”.
Power automatically shuts off after 15 minutes of no
signal input.
Automatic Power Shutoff disabled.
MOUSE ADJ.
Standby power for Monitor Out/RS-232C connection
turned off.
Monitor Out/RS-232C on
MOUSE ADJ.