Assembly instructions – Stamina Products 55-1539 User Manual
Page 6
ASSEMBLY INSTRUCTIONS
Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all
packing materials from your area and place them back into the box. Do not dispose of the packing materials
until assembly is completed. Read each step carefully before beginning. If you are missing a part please
call our toll-free number for assistance 1 (800) 375-7520 or e-mail us at: [email protected]
6
The bracket needs to
point toward the footrest.
The bracket
needs to
point
toward
the footrest.
STEP 1
Unfold the
BASE ASSEMBLY
to an upright position by moving the
FRONT FRAME(1)
away from
REAR
FRAME(2).
Then push down on the middle of the two
FOLDING LINKAGES(3)
until they are fully
locked down.
STEP 2
There is a
"L"
decal on the
LEFT PIVOT ARM(5),
and a
"R"
decal on the
RIGHT PIVOT ARM(6).
Slide the bottom of the
LEFT
and
RIGHT PIVOT ARMS(5, 6)
into the brackets located at each side of the
MAIN FRAME(4).
Align the hole on the arm with the peg on the bracket, and insert the peg into the hole
to lock the
PIVOT ARMS(5, 6)
in position. Then secure the
PIVOT ARMS(5, 6)
on the pegs with
ROUND HEAD BOLTS(M6 x 10mm)(54)
and
LARGE WASHERS(M6)(53).
STEP 3
Attach the
MAIN FRAME(4)
onto the
REAR FRAME(2)
by sliding the slots in the ends of the
PIVOT
ARMS(5, 6)
into the slots on the
REAR FRAME(2)
. Secure the
PIVOT ARMS(5, 6)
in the slots by
screwing the
BOLTS(M8 x 15mm)(45), WASHERS(M8)(51), LARGE WASHERS(M8)(52),
and
NYLOCK NUTS(M8)(49)
onto the brackets on the
REAR FRAME(2).
R
L