Assembly instructions – Stamina Products 55-1539 User Manual

Page 9

Advertising

ASSEMBLY INSTRUCTIONS

Shaft

Nylon Bed

(10) Handrail

LEFT

RIGHT

STEP 13:

Verify that the handlebars function correctly before using the

Therapy Inversion System.

Move the Nylon Bed on the

MAIN FRAME(4)

backward toward the inverted position. The

HANDRAILS(10)

must move forward as the

MAIN FRAME(4)

moves backward. If the

HANDRAILS(10)

do not move

forward check

ASSEMBLY STEPS 2, 11, and 12.

STEP 11:

Attach the

LINKAGE(7)

onto the

LEFT

HANDRAIL ASSEMBLY(8)

with the

LOCKING

KNOB(11)

. Slide the

LEFT

HANDRAIL ASSEMBLY(8)

onto the

SHAFT

in the

FRONT FRAME(1)

and secure in position with the

LOCKING KNOB(11).

Repeat on other side.

STEP 10:

Slide the

LEFT

and

RIGHT PROTECTIVE COVERS(26, 27)

onto each side of the

BASE

ASSEMBLY.

Make sure the

SHAFTS

on the

FRONT FRAME(1)

poke out through the hole on the

PROTECTIVE COVERS(26, 27).

NOTE: Do not secure the

PROTECTIVE COVERS(26, 27)

to the

FOLDING LINKAGES(3)

with the

SECURING STRAPS

on the covers until

STEP 12.

STEP 12:

Attach the

LINKAGES(7)

onto the

LEFT

and

RIGHT PIVOT ARMS(5, 6)

with

BOLTS

(M8 x 25mm)(46), WASHERS(M8)(51),

and

NYLOCK NUTS(M8)(49).

DO NOT OVER TIGHTEN THE

BOLTS. Pull the

PROTECTIVE COVERS(26, 27)

down until the bottom of the covers are slightly lower

than the

FOLDING LINKAGES(3).

Secure the

PROTECTIVE COVERS(26, 27)

to the

FOLDING

LINKAGES

with the

SECURING STRAPS

on the covers.

NOTE: When the

PROTECTIVE COVERS(26, 27)

are assembled correctly the

FOLDING LINKAGES

(3)

should not be visible.

Advertising

Popular Brands

Popular manuals