Assembly instructions – Stamina Products 55-1539 User Manual
Page 8
ASSEMBLY INSTRUCTIONS
1.
2.
Buckle
A.
C.
B.
Buckle
8
STEP 7
Install the
HEIGHT ADJUSTMENT BEAM(12)
into
MAIN FRAME(4)
by pulling the
SPRING PIN(22)
on the
MAIN FRAME(4)
and inserting the
HEIGHT ADJUSTMENT BEAM(12)
as shown. For added
safety, thread the
SECURING KNOB(23)
into the back side of the
MAIN FRAME(4).
WARNING:
Do not use the
Therapy Inversion System
until you have verified your height setting.
Failure to use the proper height setting can result in difficulty recovering from the decline position. See
HEIGHT ADJUSTMENT
instructions on page 10.
STEP 8
Attach the
NYLON STRAP(31)
onto the
BUCKLE
on the end of the
BUCKLE STRAP(32)
by inserting
the end of the strap up through the bottom of the buckle, as shown in the illustration 1.
STEP 9
Hook the end of the
NYLON STRAP(31)
onto the loop on the back of the
MAIN FRAME(4).
Hook the
end of the
BUCKLE STRAP(32)
onto the loop on the
FRONT FRAME(1).
NOTE: The
NYLON STRAPS
are used to control the decline angle of the
Therapy Inversion System.
For a steeper decline angle, lengthen the straps. For a lessor decline angle, shorten the straps. Make
sure these
NYLON STRAPS
are tight in the buckle and check the decline angle before using the
Therapy Inversion System.