Assembly instructions – Stamina Products 55-1539 User Manual
Page 7
STEP 4:
Attach the
FOOTREST(13)
onto the
HEIGHT ADJUSTMENT BEAM(12)
with the
ADJUSTMENT KNOB(24).
NOTE:
STEP 5:
Insert the
HEEL HOLDER TUBE(17)
through the hole on the
HEIGHT ADJUSTMENT
BEAM(12)
and secure with
BOLT(M6 x 47mm)(44), WASHERS(M6)(50),
and
NYLOCK NUT(M6)(48).
Place a
HEEL HOLDER BRACKET(18)
onto a
HEEL HOLDER(19),
then slide them onto
HEEL
HOLDER TUBE(17)
together. Repeat on other side.
STEP 6:
Insert the
OUTER PAD TUBE(15)
through the hole on the
LEVER(56).
Insert the
INNER
PAD TUBE(14)
into the
OUTER PAD TUBE(15).
Align the holes on the
INNER PAD TUBE(14),
OUTER PAD TUBE(15)
, and
LEVER(56),
then bolt them together with
BOLT(M6 x 42mm)(43),
WASHERS(M6)(50),
and
NYLOCK NUT(M6)(48).
Slide the
FOAM PADS(16)
onto the
INNER
and
OUTER PAD TUBES(14, 15).
WARNING:
ASSEMBLY INSTRUCTIONS
7
The
PAD TUBES(14, 15)
must be assembled with the ends pointed downward as shown.
The ends must be pointed downward to properly secure the users feet in place during inversion.
Improper assembly will allow the user's feet to come loose and the user will fall from the
inversion table.
The four adjustment holes in the
FOOTREST(13)
allow the
FOOTREST(13)
to be attached in
four different positions. Start with one of the center positions and adjust if necessary. Use the outer
position if users are taller than average. Use the inner position if users are shorter than average.