Smeg STA6047 - Manual (Page 11)

If an alarm occurs the appliance interrupts the program in progress and
signals a fault.
• Alarms E1, E2, E3, E4, E8 and E9 interrupt the current program
immediately.
• The E5, E6 alarms interrupts the running program once the cause is
resolved, it will bring bach the execution of the program.
• The alarm E7 is visualized at the end of the cycle that comes, however,
brought to the end since the operation of the dishwasher is not harmed.
To “reset” an alarm is necessary:
• Open and close the door, or turn off and on the machine. At this point is
possible to program the dishwasher again.
If the malfunction persists, contact your authorised Service Centre.
Light off Light on
Light flashing
FAULT DESCRIPTION
E6
E7
E8
E9
Water pump-out malfunction
The appliance does not pump out the water or does
not do so correctly.
Check that the drain hose is not kinked or crushed
and that the siphon and filter are are not fouled.
If the problem persists, contact the after-sales
service.
Turbine flow-regulator (for the relevant models only)
The appliance is not able to “measure” the amount
of water loaded accurately. Interrupt the program
and switch off the dishwasher.
Switch the dishwasher back on, program it again
and start the washing cycle. If the problem persists,
contact the after-sales service.
Alternate washing system malfunction
Interrupt the program and switch off the dishwasher.
Switch the dishwasher back on, program it again
and start the washing cycle.
If the problem persists,contact the after-sales
service.
Water intake system malfunction
Contact the after-sales service.
22
User instructions