Sony MSW-A2000P - Manual (Page 12)

1-6 MSW-A2000
MSW-A2000P
Plate nut (small)
Rail bracket
Rail
Flat washer
Hexagon socket
head cap screw
L-shaped hexagon wrench
By 4U
2U
Rack
50 to 55 mm
Outer rail
Rack angle B4 x 8
Rail bracket
. Attaching the outer rails
12. Loosely attach the two outer rails to the middle of the
4U space in the rack for mounting this unit, with the
eight hexagon socket head cap screws, eight flat
washers, and four plate nuts (small).
13. As shown in the following figure, adjust each front-
side position of the outer rails on both sides (left and
right) so that the distance from the surface of the rack
to the tip of the rail becomes within the range of 50 to
55 millimeters.
14. Fully tighten the eight screws (B4 x 8) fixing the four
rail brackets.
Tightening torque: 120
x 10 _2 N . m {12.2 kgf . cm}
1-6. Rack Mounting
. Loosely attaching the rail brackets
10. Slide the intermediate rail as shown in the figure, and
then loosely attach the rail bracket to the outer rail
with a plate nut (large) and the two screws.
11. Slide the ball retainer in the direction of the arrow, and
then loosely attach the rail bracket to the outer rail
with a plate nut (large) and the two screws.
Plate nut (large)
Rail bracket
Outer rail
Intermediate rail
B4 x 8
Plate nut (large) Rail bracket
Outer rail
Intermediate rail
B4 x 8
Ball retainer