Sony MSW-A2000P - Manual (Page 27)

1-21 MSW-A2000
MSW-A2000P
Back view
Mode selection plate
Screw
Round hole Search dial shaft
The shaft is seen.
Back view
Mode selection plate
Screw
Round hole
The shaft is not seen.
Back view
Mode selection plate
Portion A
Screw
Search dial
Release lever
Lower control panel unit
Release lever
4. Check to see that the shaft of the search dial is not seen
in the round hole of the mode selection plate, and then
tighten the screw.
Allowing Search Dial Pressing
1. Open the lower control panel. (Operation side up)
2. Loosen a screw on the backside of the search dial as
shown in the figure.
3. Fully slide the mode selection plate in the direction
indicated by the arrow.
4. Check to see that the shaft of the search dial is seen in
the round hole of the mode selection plate, and then
tighten the screw.
1-13. Switching Search Dial Mode
1-13. Switching Search Dial Mode
There are two kinds of operation to switch the search dial
on the lower control panel between jog mode and shuttle
mode.
. SHUTTLE/JOG button selecting
To enter the shuttle mode, press the SHUTTLE button.
To enter the jog mode, press the JOG button.
. Search dial pressing
When you press the dial, the search dial toggles between
shuttle and jog modes.
It is possible to prohibit a manner of toggling.
Prohibiting Search Dial Pressing
1. After pressing the release levers, open the lower
control panel as shown in the figure below.
2. Loosen a screw on the backside of the search dial as
shown in the figure.
n
If it is difficult to loosen the screw, remove the lower
control panel unit in advance.
(Refer to Section 1-12.)
3. Slide the mode selection plate in the direction indicat-
ed by the arrow until it contacts the portion A.