Connecting the dvd recorder, Other type of connecting the video output cable, English – Samsung DVD-R135 User Manual

Page 17

Advertising
background image

English -

17

Connecting the DVD
Recorder

1. Disconnect the aerial cable from your TV and

connect it to

on the rear panel of the DVD

Recorder.

2. Connect

of the DVD Recorder and the aerial

input of your TV using the supplied aerial cable.

3. Use the Video/Audio Cable to connect ANALOG

AUDIO OUT(R/L)/VIDEO OUT jacks on the DVD
Recorder to the Audio &Video jacks on the TV.

4. Plug in the DVD Recorder and TV.

5. Turn on the DVD Recorder and TV.

6. Press the

INPUT SEL.

button on your TV remote

control until the Video signal from the DVD Recorder
appears on the TV screen.

DVD Recorder

TV

or

or

Wall

C

onnecting & Setting Up

The RF cable connection of this DVD
Recorder sends only signals of TV.
You must connect Audio/Video cables to
watch a signal from your DVD Recorder.

To watch TV programmes, power off the
DVD Recorder.

NOTE

There are several ways to output video signal.
Select one of the following video connecting that best
suits you below.

Case 1 :

Connecting to a Video (Composite) output
jack

Case 2 :

Connecting to an S-Video output jack

Case 3 :

Component Video output jacks

S-Video, Component video and Progressive
Output Modes

S-Video and Component video output are available
only if your TV supports S-Video input or Component
video input, respectively. If S-Video or Component
video output does not work, check the TV
connections and the TV input selection settings.

Compared to standard interlaced video, progressive
scan doubles the amount of video lines fed to your
TV, resulting in a more stable, flicker-free, clear
image than interlaced video.
This is only available with TVs that support
progressive scan.

Progressive Scan Output (576p)
Consumers should note that not all high definition
television sets are fully compatible with this DVD
Recorder and may cause artifacts to be displayed in
the picture, in case of 576 progressive scan picture
problems, It is recommended that the user switch the
connection to the ‘standard definition’ output. If there
are questions regarding our TV set compatibility with
this model 576p DVD Recorder, please contact our
customer service centre.

Other type of connecting
the Video output cable

01094A-R135-XSS-ENG_17~37 3/28/06 4:19 PM Page 17

Advertising