Samsung DVD-R135 - Manual (Page 31)

English - 31
S
ystem Setup
Dynamic Compression
This is only active when a Dolby Digital signal is
detected.
1.
On : When Movie soundtracks are played at low
volume or from smaller speakers, the system
can apply appropriate compression to make
low-level content more intelligible and prevent
dramatic passages from getting too loud.
2. Off : You can enjoy the movie with the standard
Dynamic Range.
NICAM
NICAM programmes are divided into 3 types. NICAM
Stereo, NICAM Mono and Bilingual (transmission in
another language). NICAM programmes are always
accompanied by a standard mono sound broadcast and
you can select the desired sound by setting NICAM on
or off.
1. On : NICAM mode
2. Off : Only set at this position to record the standard
mono sound during a NICAM broadcast if the
stereo sound is distorted due to inferior
reception conditions.
If the TV supports Progressive Scan, press the
P.SCAN button on the front of the DVD Recorder to
enjoy.
1 With the DVD Recorder in Stop mode,
press the
P.SCAN button on the front of the
DVD Recorder.
The message “Press [Yes] to confirm Progressive
scan mode. Otherwise press [No]” will appear.
2 Press the œ √ buttons to select Yes , and
then press the OK button.
3 Set your TV to Progressive input (using the
TV remote control.)
Setting up the Progressive
scan
■ When the HDMI cable is connected, this
screen is not displayed.
■ Do not press the P.SCAN button if you
are using a TV that does not support
Progressive mode. Nothing will be
displayed on the screen if pressed.
■ Progressive setting is only available when
the DVD Recorder is connected to your
TV using component cables.
■ If the P.SCAN button on the DVD recorder’s
front panel is pressed during playback, the
prohibition mark( ) appears on the screen.
■ Progressive setting is only available when
the DVD recorder is in stop mode.
NOTE
No Yes
Press [Yes] to confirm Progressive scan mode.
Otherwise press [No]
01094A-R135-XSS-ENG_17~37 3/28/06 4:19 PM Page 31