Seiko Group 201 - Manual (Page 28)

26
Jumper setting
Set the jumpers on the DM-D stand as follows:
The jumpers are located as follows:
Precautions on using the power supply unit
To avoid damage to the DM-D500 and the power supply unit, make
sure to note the following points.
❏ Use the optional Seiko Epson products, PS-170, or PA-6508,
PA-6511, PA-6513, PB-6509 or PB-6510 as the power supply.
❏ Never connect the DC cable to the power supply unit when the
power supply unit is connected.
❏ Unplug the DC cable by holding the connector part. If you pull the
cable to unplug, it may be damaged.
JP1 JP2 Contents
1-2 1-2 Set the jumpers as in the left columns when connecting both the TM
printer and the DM-D stand. (Default setting)
2-3 2-3 Set the jumpers as in the left column when using the DM-D stand as
stand alone. (TM printer is not connected.)